ADE CK 2303 Instrucciones De Operación página 30

During this process, the displayed time is compared
with that received from the time signal transmitter
and, if necessary, corrected.
If the radio-controlled clock does not receive
a strong enough signal, signal reception will be
terminated after a few minutes, and the radio tower
symbol will be displayed without radio waves.
The receiving process is started again at a later point
in time. In this case, the time proceeds as usual
(beginning with the start time of "00:00").
Checklist when data is missing on the
display
1. Check whether the location of the clock is
suitable, see "Choosing a location".
2. Manually restart the receiving process, see
"Starting signal reception manually".
3. Wait until the clock automatically switches
back to receiving mode at a later time.
4. Manually perform settings if reception is not
possible at your location, see "Setting the
time manually".
Setting the time manually
‚ If more than 20 seconds elapse between
‚ You will hear a beep each time you
1. Remove the battery compartment cover to
access the setting buttons.
2. Keep the SET button pressed until "BEEP ON"
appears on the display.
30
two button presses, the setting process
is terminated automatically, and you
have to start over.
press the button (depending on the
setting).
CK 2303 DCF radio-controlled alarm clock