Metabo C 12RSH3 Manual página 18

English
7. Securing the workpiece
WARNING
Always clamp or vise to secure the workpiece to
the fence; otherwise the workpiece might be
thrust from the table and cause bodily harm.
8. Installing the side holder
The side holder helps keep longer workpieces stable
and in place during the cutting operation.
As indicating in Fig. 14, installing the side holder in
the holes on the side of base and fasten it with 6 mm
bolt.
6 mm bolt
Side holder
CAUTION
When transporting or carrying the tool, do not
grasp the holder. There is the danger of the
holder slipping out of the base.
For the correct way to hold the tool, refer to
"TRANSPORTATION OF THE MAIN BODY".
9. Installing the holders ... (Optional accessory)
The holders help keep longer workpieces stable and
in place during the cutting operation.
(1) As indicated in Fig. 15, use a steel square for aligning
the upper edge of the holders with the base surface.
Loosen the 6 mm wing nut. Turn a height adjustment
bolt 6 mm, and adjust the height of the holder.
(2) After adjustment, firmly tighten the wing nut and
fasten the holder with the 6 mm wing knob (optional
accessory). If the length of Height Adjustment Bolt
6 mm is insufficient, spread a thin plate beneath.
Make sure the end of Height Adjustment Bolt 6 mm
does not protrude from the holder. (Fig. 15)
18
Base
Fig. 14
Holder
(Optional accessory)
Steel square
6 mm wing nut
(Optional
Height adjustment bolt 6 mm
accessory)
(Optional accessory)
10. Stopper for precision cutting ... (Stopper and holder
are optional accessory)
The stopper facilitates continuous precision cutting in
lengths of 11 in. to 17-3/4 in. (280 mm to 450 mm).
To install the stopper, attach it to the holder with the
6 mm wing bolt as shown in Fig. 16.
Stopper
(Optional accessory)
Workpiece
Move
6 mm wing bolt
(Optional accessory)
11. Slide carriage system
WARNING
To reduce the risk of injury, return slide carriage
to the full rear position after each crosscut
operation.
For chop cutting operations on small workpieces,
slide the cutting head assembly completely toward
the rear of the unit and tighten the slide securing
knob.
6 mm knob bolt
(Optional accessory)
Base surface
Fig. 15
Holder
(Optional accessory)
6 mm wing nut
(Optional
accessory)
Height adjustment
bolt 6 mm
(Optional accessory)
Fig. 16