Publicidad
Idiomas disponibles
Idiomas disponibles
English
Adjusting line
ⓐ
ⓐ
ⓐ
Marking
(pre-marked)
(Front view)
(2) Once the saw blade reaches maximum speed, push
the handle down carefully until the saw blade
approaches the workpiece.
(3) Once the saw blade contacts the workpiece, push the
handle down gradually to cut into the workpiece.
(4) After cutting the workpiece to the desired depth, turn
the power tool OFF and let the saw blade stop
completely before raising the handle from the
workpiece to return it to the full retract position.
WARNING
● Confirm that the trigger switch is turned OFF and
the power plug has been removed from the
receptacle whenever the tool is not in use.
● Always turn the power off and let the saw blade
stop completely before raising the handle from
the workpiece. If the handle is raised while the
saw blade is still rotating, the cut-off piece may
become jammed against the saw blade causing
fragments to scatter about dangerously.
● Every time one cutting or deep-cutting operation
is finished, turn the trigger switch off, and check
that the saw blade has stopped. Then raise the
handle, and return it to the full retract position.
● Be absolutely sure to remove the cut material
from the top of the turntable, and then proceed
to the next step.
22
ⓑ
ⓑ
Saw blade
ⓑ
Marking
(pre-marked)
Fig. 25
● Continued cutting operation can result in
overload of the motor. Touch the motor and if it's
hot, stop your cutting operation at once and rest
for 10 minutes or so, and then restart your
cutting operation.
CAUTION
Increased pressure on the handle will not
increase the cutting speed.
On the contrary, too much pressure may result in
overload of the motor and/or decreased cutting
efficiency.
4. Cutting narrow workpieces (Press cutting)
Slide the hinge down to holder (A), then tighten the
slide securing knob.
Lower the handle to cut the workpiece. Using the
power tool this way will permit cutting of workpieces
of up to 4-3/16" (107 mm) square.
Press down
Hinge
5. Cutting large workpieces
There may be case when a complete cutting cannot
be done depending on the height of workpiece. In this
case, mount an auxiliary board with the 6 mm flat
head screws and the 6 mm nuts using the 7 mm holes
on the fence surface (two holes on each side).
Refer to page 11 "Table 2: Max. sawing dimension"
for the thickness of the auxiliary board.
6 mm nut
Fence
Slide Securing Knob
Holder (A)
Fig.26
6 mm flat hd. screw
Auxiliary board
Fig. 27
Publicidad
