Publicidad
Idiomas disponibles
Idiomas disponibles
English
6. Storage
After operation of the tool has been completed, check
that the following has been performed:
(1) Trigger switch is in OFF position,
(2) Power plug has been removed from the receptacle,
When the tool is not in use, keep it stored in a dry place
out of the reach of children.
7. Lubrication
Lubricate the following sliding surfaces once a month
to keep the power tool in good operating condition for
a long time (see Fig. 2 and Fig. 3). Use of machine oil
is recommended.
Oil supply points:
○ Rotary portion of hinge
○ Rotary portion of vise assembly
○ Rotary portion of holder (A)
8. Cleaning
Duct
Air gun
Clean the machine, duct and lower guard by blowing with
dry air from an air gun or other tool.
Periodically remove chips, dust and other waste material
from the surface of the power tool, especially from the
inside of the lower guard with a damp, soapy cloth. To
avoid a malfunction of the motor, protect it from contact
with oil or water.
If the LED light becomes invisible due to chips and the like
adhered onto the window of the LED's light-emitting
section, wipe and clean the window with a dry cloth or a
soft cloth moistened with soapy water, etc.
CAUTION
In the operation and maintenance of power tools,
the safety regulations and standards prescribed
in each country must be observed.
34
Lower Guard
Fig. 53
MODIFICATIONS:
metabo HPT Power Tools are constantly being improved
and modified to incorporate the latest technological
advancements.
Accordingly, some parts may be changed without prior
notice.
SERVICE AND REPAIRS
All quality power tools will eventually require servicing or
replacement of parts because of wear from normal use.
To assure that only authorized replacement parts will be
used, all service and repairs must be performed by a
metabo HPT AUTHORIZED SERVICE CENTER, ONLY.
NOTE
Specifications are subject to change without any
obligation on the part of metabo HPT.
Publicidad
