Metabo C 12RSH3 Manual página 29

Position in
Fig. 34
①
For inside
corner
②
③
For outside
corner
④
11. Groove cutting procedures
Cut grooves with saw blade
6 mm depth adjustment bolt
Hinge
Turntable
Grooves in the workpiece can be cut as indicated in
Fig. 44 by adjusting the 6 mm depth adjustment bolt.
Cutting depth adjustment procedure:
(1) Lower the motor head, and turn the 6 mm depth
adjustment bolt by hand shown in Fig. 45. (Where the
head of the 6 mm depth adjustment bolt contacts the
hinge.)
Finished
Miter angle
piece
Save the
Right 45° right side of
blade
Save the left
side of
blade
Left 45°
Save the
right side of
blade
Save the left
Right 45° side of
blade
ⓐ
ⓑ
Fig. 44
Bottom line of
the groove
ⓑ
Fig. 45
(2) Adjust to the desired cutting depth by setting the
distance between the saw blade and the surface of
the turntable (see ⓑ in Fig. 44).
NOTE
When cutting a single groove at either end of the
workpiece, remove the unneeded portion with a
chisel.
12. Cutting easily-deformed materials, such as aluminum
sash
Materials such as aluminum sash can easily deform
when tightened too much in a vise assembly. This will
cause inefficient cutting and possible overload of the
motor. When cutting such materials, use a wood plate
to protect the workpiece as shown in Fig. 46-a. Set
the wood plate near the cutting section.
Fence
When cutting aluminum materials, coat the saw blade with
cutting oil (non-combustible) to achieve smooth cutting
and a fine finish. In addition, in case of a U-shaped
workpiece, use the wood plate as shown in Fig. 46-b to
ensure stability in the lateral direction, and clamp it near
the cutting section of the workpiece and tighten it using
both the vise assembly and the clamp available in the
market.
Vise assembly
Wood plate
English
Vise assembly
Wood plate
Aluminum sash
Wood plate
Fig. 46-a
Clamp
Wood plate
Aluminum sash
Fig. 46-b
29