Bianchi SPECIALISSIMA RC Manual Suplementaria página 6

WARNING!
Turn the handlebar left and right. Do not use the bike if there is any evidence of abnormal steering (play in the steering or uneven
resistance) or if any cracks or signs of damage are evident.
In the event of an accident or fall, the handlebar will almost certainly be involved and will be subjected to high levels of stress and impact.
In the event of any deep scratches or cracks, replace the components.
WARNING!!
If the handlebar is damaged, stop using the Specialissima RC and/or PRO bike
immediately. Do not use the Specialissima RC and/or PRO bike until a specialist
retailer has conducted a full inspection and, if necessary, the handlebar has been
replaced.
The gear/brake control levers are mounted on the handlebar using a clamp integrated
into the lever.
Pay close attention to the recommended positioning of the levers and respect the limits
indicated by the high grip zone (image 1A).
Consult the lever product handbook for the correct torque. To preserve the integrity of
the handlebar bend, do not exceed the maximum torque of 10 Nm.
BIKE COMPUTER MOUNT FOR SPECIALISSIMA RC AND PRO INTEGRATED HANDLEBAR
The integrated handlebar provided with the Specialissima RC and PRO models is compatible with bike computer mounts
that are attached to the handlebar using two M5 screws.
Tighten the screws to the recommended torque of 2/3 Nm, as indicated on the handlebar.
Always use the safety strap supplied with the bike computer to fasten it to the handlebar.
WARNING!!
Check that the mount is installed correctly before using the bike computer.
SPECIALISSIMA COMP HANDLEBAR STEM AND BEND
The handlebar kit provided with the Specialissima Comp frame is composed
of a stem and bend designed specifically for this frame and uses Velomann
components.
The Specialissima Comp frame uses the ICR head set system manufactured
by Acros to route the cables within the handlebar and frame. The handlebar is
designed to integrate seamlessly with the head set.
During assembly, the cables enter the handlebar bend near the levers and exit
under the stem, and then enter the frame through the spacers and head set.
The height of this type of handlebar stem is adjustable by a specialist retailer.
Due to the importance and complexity of this component, please consult your
retailer for stem adjustment and to fully understand the mechanisms and
adjustment methods.
DANGER!
Always comply with the torque values specified on the stem. Incorrect tightening may cause the component to malfunction or
break, causing the rider to lose control and fall.
Never use this product with incomplete or incorrect assembly. This endangers not only the rider but also other road users.
WARNING!!
Turn the handlebar left and right. Do not use the bike if there is any evidence of abnormal steering (play in the steering or uneven
resistance) or if any cracks or signs of damage are evident.
6
image 1A