Publicidad
Installing the holster
1 Insert the multimeter into the lower part of the orange rubber holster.
2 Press the top part of the multimeter to secure the orange rubber holster.
Figure 1-2
Installing the batteries
Your multimeter is powered by four 1.5 V AA batteries (included with the shipment). When
you receive your multimeter, the batteries are not installed.
Use the following procedure to install the batteries.
Before you proceed with the battery installation, remove all cable connections to the
CAUTION
terminals and ensure that the rotary switch is at the OFF position. Use only the battery
type specified in the datasheet.
Keysight U1281A/U1282A User's Guide
1
Installing the orange rubber holster
Introduction
1
2
23
Publicidad
