Publicidad
This warning is intended to stop you from attempting to measure voltage, continuity,
resistance, capacitance, diode, or temperature values when the leads are plugged into a
current terminal.
The red LED on the multimeter turns on briefly and the multimeter emits a brief beep and
displays
current position but no test leads are inserted into the
Figure 1-5
Adjusting the tilt stand
To adjust the multimeter to a 60° standing position, pull the tilt-stand outward to its
maximum reach.
Figure 1-6
Keysight U1281A/U1282A User's Guide
in the secondary display when the rotary switch is set to the
Input warning display
Tilt-stand adjustment and IR-USB cable connection
Introduction
or
mA
input.
A
To PC (host)
1
or
mA
A
31
Publicidad
