KYT KX-1 RACE Manual De Instrucciones página 34

Inner side padding: CHEEK PADS — G — Figure 8
Assembly and disassembly
EN
Removing the pads — Figure 9
Grab the cheek pad (G) from the front part, push it towards the back part of the helmet and then
pull outwards until all the press studs are unhooked.
G
G G
G G
FIGURE 8 FIGURE 9
Assembly — Figure 10
Turn upside down the cheek pads from the original position.
Insert the fixing hook (H) in the red hooking hole (I)
Put the back part of the cheek pad on the fixed part of the inner lining. Verify that the fastening
strap (L) is correctly inserted in the appropriate seat (M). Push the cheek pad to the back part of
the helmet and hook the press studs.
Verify that the part was assembled correctly by checking that:
- the cheek pad is firmly locked in position
- the strap is completely free inside the hole and is not blocked under the cheek
pad during assembly.
Only the correct assembly of the cheek pad and the correct positioning of the strap
will assure the proper efficacy of the retention system. During use, the locking
lever must always be fixed in lock position; if it cannot be locked correctly do not
use the helmet.
H
L
I
M
34
FIGURE 10