KYT KX-1 RACE Manual De Instrucciones página 37

Removing the visor — Figure 12
Open the visor until it is completely open.
EN
Slide the lever (Q) and Keep it in tension (Q)
Remove the visor from its mechanism by rotating and at the same time by pulling it outwards.
Repeat the operation on the opposite side.
1
Q
Q
FIGURE 12
Assembly — Figure 13
To assure the proper operation of the rotation system of the visor, before fitting
the visor back on, verify that all the parts (seats on helmet, visor surface in contact
with the moving parts) are perfectly clean.
Open the visor completely. Position the visor on the mechanism so that the rotation seat is inserted
in the rotation ring.
1) Slide the lever (Q)
2) Press slightly to stick the hooks on the visor into the slots on the rotation mechanisms
Repeat the operation on the opposite side.
After fitting the mechanism verify that the visor is tightly fixed to the helmet, that it rotates freely
and that it locks correctly into the locking positions.
If this doesn't happen and the rotation mechanism of the visor doesn't work cor-
rectly, do not use the helmet and contact KYT authorized personnel only.
2
S
Q
1
37
FIGURE 13