KYT KX-1 RACE Manual De Instrucciones página 35

VISOR — N
The visor must be periodically cleaned and controlled. If the visor is dirty and/or has bad scratches
EN
on the surface there could be unusual light reflections or deviations, which may jeopardize safety.
Immediately replace the visor if there are these problems.
How to operate — Figure 11
The Visor has to be operated only by using the lifting lever.
Do not open it using other areas to avoid causing accidental damages (scratches or lines) or dirtying
the field of vision.
Opening the visor: push lightly the lifting lever outwards (O),
to unlock the tab from its seat (P) under the gasket and lift it up.
Closing the visor: to lock the visor in position, lower it until the tab is blocked inside its seat (P) in
the gasket.
There are two locking positions (visor completely open/closed) and five intermediate positions. The
visor must be opened or closed completely up to the lock position. The visor is correctly locked
into position when it clicks into its seat. To unlock the visor from the lock position just follow the
above procedure, lightly press during initial phase of the movement until the visor is unlocked.
While riding the motorcycle the visor must never be left in the intermediate
positions; it must always be locked in the locking positions.
N
O
P
N
FIGURE 11
O
O
35