KYT KX-1 RACE Manual De Instrucciones página 38

Adjustment — Figure 14
If after replacing the part, or after long use of the helmet, you experience infiltration from the closed
EN
visor, it may be necessary to adjust the mechanisms of the visor.
Lift the visor until it is completely open.
Remove the visor, as specified in the previous paragraph.
Loosen the two screw (R - S) without removing them and without disassembling the mechanism.
Shift horizontally the whole mechanism and tighten the screws.
Repeat the operations on the opposite side by shifting the mechanism on the same direction of the
previous one.
Once finished, check if the visor can be easily closed and if it adheres to the gasket.
VISOR MECHANISM
Replacement — Figure 15
Removing the mechanism
After removing the visor as indicated in the paragraphs above, loosen and remove the screws (R - S –
S1); then remove the mechanism from the shell.
Fitting the mechanism
The mechanisms are not interchangeable. Before proceeding it is necessary to
identify the correct assembly side;
Put the mechanism on the shell, insert the screws tightening them.
38
R
S
S
R
S
S1
FIGURE 14
FIGURE 15