Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Assembly — Figure 11-B
To assure the proper operation of the rotation system of the visor, before fitting the
visor back on, verify that all the parts (seats on helmet, visor surface in contact with
the moving parts) are perfectly clean.
Open the visor completely. Position the visor on the mechanism so that the rotation seat is inser-
ted in the rotation ring.
1) Slide the lever (T)
2) Press slightly to stick the hooks on the visor into the slots on the rotation mechanisms
Repeat the operation on the opposite side.
After fitting the mechanism verify that the visor is tightly fixed to the helmet, that it rotates freely
and that it locks correctly into the locking positions.
If this doesn't happen and the rotation mechanism of the visor doesn't work correct-
ly, do not use the helmet and contact authorized personnel only.
Adjustment — Figure 12
After replacing the part, or after long use of the helmet you experience infiltration from the clo-
sed visor, it may be necessary to adjust the mechanisms of the visor.
Lift the visor until it is completely open.
Remove the visor, as specified in the previous paragraph.
Loosen the screws (V - W) without removing them and without disassembling the mechanism.
Shift horizontally the whole mechanism and tighten the screws.
Repeat the operations on the opposite side by shifting the mechanism on the same direction of
the previous one.
Once finished, check if the visor can be easily closed and if it adheres to the gasket
V
W
FIGURE 12
VISOR MECHANISM
Removing the mechanism
After removing the visor as indicated in the paragraphs above, loosen and remove the screws
(V - W); then remove the mechanism from the shell.
Fitting the mechanism
The mechanisms are not interchangeable. Before proceeding it is necessary to iden-
tify the correct assembly side. Put the mechanism on the shell, insert the screws tightening
them.
14
Publicidad
