Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Inner side padding: CHEEK PADS — H — Figure 7/8
Removing and Assembly
Removing — Figure 7
Cheek pad is fixed to the shell through three press studs, to remove unfasten the three studs by
slightly pulling outwards. After unfastening the buttons, slide out the pad by releasing the strap
from the slot in the pad.
FIGURE 7
Assembly — Figure 8
Turn upside down the cheek pads from the original position.
Insert the fixing hook (L) in the red hooking holes (M). Put the back part of the
cheek pad on the fixed part of the inner lining. Verify that the fastening strap is
correctly inserted in the appropriate seat. Push the cheek pad to the back part of
the helmet and hook the press studs.
FIGURE 8
22
H
L
L
M
M
Verify that the part was assembled correctly by checking that:
– the cheek pad is firmly locked in position
– the strap is completely free inside the hole and is not blocked under the
cheek pad during assembly.
Only the correct assembly of the cheek pad and the correct positioning of the
strap will assure the proper efficacy of the retention system. During use, the
locking lever must always be fixed in lock position; if it cannot be locked cor-
rectly do not use the helmet.
SECURITY SYSTEM — Figure 9
To remove the helmet in case of an accident
SKYHAWK is equipped with a system that easily remove the cheek pads with the helmet
worn in case of a crash
In case of emergency pull out the red tape (N) on the final part of the cheek pads.
FIGURE 9
EN
N
23
Publicidad
