Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly instructions
EN
657 055 202A, 657 055 202B
Part name
Towbar wiring harness
Control unit
Cable tie with clip for hole
Cable tie with clip for strut
Cable ties
Cable tie with clip for tucker
Socket cover
Notice
The cover for mounting the control unit (I) is not included in the kit.
If you install the towbar into a vehicle without the shock absorber control unit included in
the equipment, the cover for mounting the control unit must be ordered separately from the
ETKA spare parts catalog under order No. 654 971 362.
Important installation instructions
Caution! The vehicle must be clean; preferably, use a car wash.
Caution! At the points where the wiring harness passes over the edge to
the vehicle body, we recommend wrapping the harness with a suitable
abrasion-resistant tape before attaching it.
Assembly procedure
Keep the battery disconnected during installation.
When dismantling and refitting individual parts, follow the instructions in the ŠKODA
Workshop Manual.
Place the vehicle on the workshop jack arms.
Remove the following:
- Rear bumper (dirt traps, if fitted)
- Crossmember
- Tailgate lock latch cover
- Left side panel in the boot (seen in the direction of travel)
- If included in the equipment, remove the plastic rear wall cover.
Caution! Prior to the towbar installation, the SCR tank (for diesel
vehicles) or AKF tank (for petrol engines), located under the right rear
plastic wheel cover, must be removed.
Caution! After removing the crossmember, apply an anti-corrosion
agent at the points of contact of the crossmember with vehicle body.
After treating the vehicle body with anti-corrosion protection, re-install
the removed screws from the crossmember (Fig. 6).
- 2 -
- Towbar wiring layout in the vehicle.
12
1
Qty.
Location
1
D
1
E
5
F
1
G
9
H
1
J
1
K
Publicidad
