TOPDON Phoenix Max Manual Del Usuario página 33

3.26 TYPE (Tire Reset)
This function can set the parameters of the size of the modified or replaced tire.
3.27 WINDOWS (Windows Calibration)
This feature can perform door window matching to recover ECU initial memory, and
recover the automatic ascending and descending function of power window.
3.28 LANGUAGE (Language Change)
This function can change the system language of the vehicle central control panel.
3.29 AC System Relearn/Initialization
If the ECU or actuator of the vehicle air conditioner is replaced, or the memory of the
ECU memory is lost, air conditioner initialization learning is needed.
3.30 Engine Power Balance Monitoring
At the power stroke of each cylinder, power balance monitors crankshaft acceleration,
thus determining the relative power provided by each cylinder.
3.31 Gas Particulate Filter Regeneration
After long-term use of the particle catcher, fuel consumption can be increased, engine
output power can be decreased, then in this case, the GPF needs to be replaced or
regenerated.
3.32 High Voltage Battery Diagnostics
For diagnosis and state information detection on high-voltage accumulator.
3.33 Intelligent Cruise Control System
For replacement of intelligent cruise control system of vehicle and matching after
repairing.
3.34 Motor Angle Calibration
There is a deviation between the rotor position detected by the angle position sensor of
the motor and the actual rotor magnetic field position, so it is necessary to calibrate the
motor angle.
3.35 IMMO PROG (Optional)
Anti-theft editor supports vehicle key chip read and write, EEPROM chip read and write,
MCU chip read and write, engine ECU and transmission ECU EEPROM and FLASH read
and write.
30