Descargar Imprimir esta página

Greencut JET-2600SX Manual De Instrucciones página 75

Ocultar thumbs Ver también para JET-2600SX:

Publicidad

Idiomas disponibles

Idiomas disponibles

USING THE PRODUCT
BEFORE USING THE PRODUCT
ATTENTION: Ensure that you carry out all procedures below before starting the engine or operating
the equipment. All procedures described are generic in nature and slight variations between
different models may exist. Failure to follow the checklist and carry out the procedures correctly
may result in making the product warranty void.
The product is NOT supplied with engine oil, although traces of oil from the manufacturing process may be present.
It is essential to add adequate engine oil of the correct type to the engine before use. Failure to add engine oil will
void the product warranty.
ENGINE OIL
Four-stroke engines require engine oil in the crankcase for lubrication of internal components.
Severe or irreparable damage may occur if the engine is allowed to run without engine oil. The engine oil level requires
regular maintenance. Check the engine oil level and ensure that the oil level is at or just under the maximum level
indicator.
Always check the engine oil level before starting the engine.
AIR FILTER
The air filter is used to prevent dirt and other particles from possibly entering the engine and causing internal damage
to it. The air filter requires regular maintenance. Always check the air filter before starting the engine.
FUEL
To fill or top up fuel:
1.
Place the machine in an upright position on a flat and level surface.
2.
Clean the machine around the fuel filler so that no dirt or other material enters the engine when the cap
is removed.
3.
Remove (rotate left) the fuel filler cap.
4.
Using a funnel, carefully fill the tank with fuel. Do not fill above the top of the strainer (if equipped) or
otherwise overfill the tank.
5.
When finished, reinstall (rotate right) the fuel filler cap until firm. Wipe away any residual fuel from the
machine. If fuel has been spilt, move the pump away from the spillage before starting the engine.
ATTENTION: Petrol/fuel/gasoline is extremely flammable; keep clear of naked flames or other
ignition sources. The engine must be cool before refuelling.
ATTENTION: Adequately fill the fuel tank with the correct fuel type.
PUMP OIL – NON-SEALED PUMPS ONLY
Water pumps require oil for lubrication of internal components. Severe or irreparable damage may occur if the pump
is used without oil. The pump oil for non-sealed pumps requires regular maintenance, however, does come shipped
with oil. Check the oil level and ensure that it is at or just under the maximum level indicator.
Always check the pump oil level before starting the engine.
75
EN

Publicidad

loading