Maintenance And Storage - BOX Plus 868202 Manual De Instrucciones

n) Never put the hands or feet close to or under the rotating parts. Never allow the ejection opening to
become obstructed.
o) Do not transport the machine when the power supply is applied.
P) Moving:
1- Stop the machine and remove the electric plug from its socket. Check that all moving parts have
stopped completely.
2- Stop the machine, and remove the isolating device. Check that all moving parts have stopped
completely:
− before leaving the machine,
− before cleaning blockages or unblocking the trough,
− before inspecting, cleaning or repairing the machine,
− after hitting a foreign object. Inspect the machine to detect any damage and make repairs before
restarting and using it.
If the machine starts to vibrate abnormally (check immediately):
− inspect the machine to check whether it is damaged,
− repair or replace any damaged part,
− check that parts have not become loose and tighten them if necessary.

4 MAINTENANCE AND STORAGE

a) Keep all the nuts, bolts and screws tight to as to be certain that the equipment is in good working
order.
b) Check the collection box frequently for wear or deterioration.
c) Replace worn or damaged items so that the machine remains safe.
d) On multi-blade machines, take precautions, because rotation of one cutter can lead to the rotation of
all the others.
e) Take care, when adjusting the machine, to avoid trapping fingers between moving blades and their
fixed parts.
f) Always allow the machine to cool before storing it.
g) During routine maintenance of the cutter, take care, even if the power supply is cut off, as it could still
be moving.
h) Replace worn or damaged items so that the machine remains safe. Only use spare parts and original
accessories.
5 RECOMMENDATION
We recommend supplying the machine via an RCD [Residual Current Device] with breaking current less
than or equal to 30 mA.
Remove the plug from the socket:
– whenever you leave the machine,
– before clearing a blockage,
– before checking, cleaning or working on the machine,
– after striking a foreign object. Inspect the machine for damage and make repairs as necessary,
– if the machine starts to vibrate abnormally (check immediately).
Power supply:
The voltage indicated on the rating plate must correspond to the voltage of the power source.
We recommend that this equipment is only connected into a socket which is protected by a circuit-
breaker that would be actuated by a 30 mA residual current.
Only use or replace power supply cables for this unit which correspond to the types indicated by the
manufacturer.
See the operating instructions for the order no. and types.
Never touch the mains plug with wet hands.