BOX Plus 868202 Manual De Instrucciones página 24

10. Wheels
11. Cable holder
ASSEMBLY "Fig A"
The lawn mower is delivered unassembled. The complete push bar must be assembled before using the
lawn mower. Follow the operating instructions step-by-step and use the pictures provided as a visual
guide to easily assemble the machine.
PREPARATION
1- Put the cable hook on upper handle.
2- Connect upper and lower handles with supplied screws and knobs.
3- Insert the handles into the mower body.
4- Fit each wheels over the axles, secure in place with the "R" pins and press the wheel covers into
place.
5- Fix the cable holders.
6- Grasse collection box assembly. Assemble two halves and fix them together. (Fig. H)
7- Lift the flap and place the grass box over the lugs.
SETTING THE CUTTING HEIGHTS « Fig C »
Important! Adjust the cutting height only when the engine is switched off and the power cable has been
disconnected.
Before you begin to mow, check to ensure that the blade is not blunt and that none of the fasteners are
damaged. To prevent any imbalance, replace blunt and/or damaged blades. To carry out this check, first
switch off the motor and pull out the power plug.
To obtain the desired cutting height, the front and rear axles are repositioned on the underside of the
mower housing.
Warning! Disconnect the mower from the power supply and ensure the blade has stopped coasting
before adjusting the height.
> To adjust the front wheel cutting height position
- Turn the mower upside down.
- Pull the wheel axle towards the front of the mower.
- Locate the wheel axle into the desired cutting height adjustment position.
> To adjust the rear wheel cutting height position
- Turn the mower on its side.
- Pull the rear wheel axle towards the mower's catcher flap.
- Locate the wheel axle into the desire cutting height adjustment position.
Note: Make sure that both rear right and left wheel are located in the same cutting height adjustment
position.
> 5 Cutting height positions
25mm ~ 75 mm
- 25 mm (lowest cutting height position)
- 75 mm (highest cutting height position)
OPERATION "Fig B&D"
> Connect to power supply. « Fig B »
Before you connect the equipment to the mains supply make sure that the data on the rating plate are
identical to the mains data.
Connect the plug to an extension cable. It is imperative to secure the extension cable with the cable
grip.