Cleaning And Maintenance - BOX Plus 868202 Manual De Instrucciones

> Starting « Fig D »
Press and hold safety button (A) (then squeeze the switch lever (B) towards the handle).
Release the safety button.
> Stopping
Release the switch lever.
ATTENTION: After switching off, the cutting blade will go on turning for a few seconds, make sure the
blade has come to a complete standstill.
CAUTION: Do not rapidly switch off and on.
> Safety button
Important! To prevent the machine switching on accidentally, the lawn mower is equipped with a safety
lock-off which must be pressed before the switching bar can be activated. The lawn mower switches
itself off when the switch is released.
Repeat this process several times so that you are sure that the machine functions properly.
Before you perform any repair or maintenance work on the machine, ensure that the blade is not
rotating and that the power supply is disconnected.
Important! Never open the discharge flap if the grass bag is being emptied and the motor is still running.
The rotating blade can cause serious injuries.
Always secure the discharge flap and grass bag carefully. Always switch off the motor before you
remove these items.
The safety distance between the blade casing and the user provided by the guide struts must be
maintained at all times.
> Information on correct mowing
We recommend that you mow in overlapping lines. Only mow with sharp, perfect blades so that the
blades of grass do not fray, making the lawn turn yellow.
The cutting height should be between 4 and 6 cm and the growth before the next cut should be
between 4 and 5 cm. If the lawn grows longer than this on occasion, do not make the mistake of cutting
to normal length straight away since this will damage the lawn.
Never cut the grass by more than half its height. Keep the underside of the mower casing clean and
remove all grass deposits from it. Deposits make it more difficult to start the mower and also adversely
affect the mowing quality and the grass discharge. On slopes mow across the slope (not in up or down
direction).You can counteract the tendency of the mower to slide down the slope by setting it at an
angle upwards that you do not remove more than 4 cm of grass length in any one pass.
Switch off the motor before you carry out any inspections of the blade. Remember than the blade will
continue to turn for a few seconds after the motor has been switched off. Never attempt to stop the
blade.
Check regularly that the blade is correctly secured, in good condition and well ground. If not, grind or
replace the blade. If the moving blade strikes an object, stop the mower and wait until the blade has
come to a complete standstill. Then check the condition of the blade and the blade holder. If they are
damaged, they must be replaced.
Place the mains lead in loops on the ground in front of the socket. Mow away from the socket and cable
and ensure that the mains lead is always on the section of lawn that you have already mowed so that
you do not run over the mains lead with the mower. As soon as you see mown grass on the lawn whilst
you are mowing, the grass bag will need emptying.

CLEANING AND MAINTENANCE

Attention! Before performing any work on the equipment, pull out the power plug.
> Cleaning