Publicidad
Idiomas disponibles
Idiomas disponibles
1. Loosen the bar nut that hold the clutch
cover/chain brake. Use the combination
wrench.
2. Tighten the bar nuts by hand as tightly as
you can.
3. Lift the front of the guide bar and turn
the chain tensioning screw. Use the
combination wrench.
4. Tighten the saw chain until it is tight
against the guide bar but still can move
easily.
5. Tighten the bar nuts using the wrench and
lift the front of the guide bar at the same
time.
6. Make sure you can pull the saw chain
around freely by hand and that it does not
hang from the guide bar.
16
To lubricate cutting equipment
WARNING:
cutting equipment may cause the
chain to snap, which could lead to
serious, even fatal injuries.
WARNING:
oil! Waste oil is dangerous for
persons, the product and for the
environment.
Chain oil
•
Chain oil must demonstrate good adhesion
to the chain and also maintain its flow
characteristics regardless of whether it is
warm summer or cold winter weather.
•
As a chain saw manufacturer we have
developed an optimal chain oil which,
with its vegetable oil base, is also
biodegradable. We recommend the use of
our own oil for both maximum chain life
and to minimize environmental damage.
•
If our own chain oil is not available,
standard chain oil is recommended.
•
In areas where oil specifically for
lubrication of saw chains is unavailable,
ordinary EP 90 transmission oil may be
used.
The oil pump is preset at the factory to meet
most lubrication requirements. A full oil tank
will last about half as long as a full tank of
fuel. You should therefore check the level of
oil in the oil tank regularly to avoid damage to
the saw chain and bar that could occur due to
lack of lubrication.
To adjust chain lubrication
WARNING:
motor before you make
adjustments to the oil pump.
Poor lubrication of
Do not use waste
Stop the engine/
2106 - 001 - 07.08.2023
Publicidad
