Publicidad
Idiomas disponibles
Idiomas disponibles
from overhead electric power lines and
ensure that the operating position is safe
and secure before operating the saw chain
pole pruner.
•
Keep all parts of the body away from the
saw chain. Do not remove cut material
or hold material to be cut when blades
are moving. Make sure the switch is off
when clearing jammed material. Saw chain
continues to move after the switch is
turned off. A moment of inattention while
operating the extended-reach pruner may
result in serious personal injury.
•
Carry the extended-reach pruner by the
handle with the saw chain stopped. When
transporting or storing the extended-reach
pruner, always fit the saw chain device
cover. Proper handling of the extended-
reach pruner will reduce possible personal
injury from the saw chain.
•
Hold the extended-reach pruner by
insulated gripping surfaces only, because
the saw chain may contact hidden wiring.
A saw chain contacting a "live" wire
may make exposed metal parts of the
extended-reach pruner "live" and could
give the operator an electric shock.
•
Do not use the extended-reach pruner in
bad weather conditions, especially when
there is a risk of lightning. This decreases
the risk of being struck by lightning.
•
To reduce the risk of electrocution, never
use near any electrical power lines.
Contact with or use near power lines
may cause serious injury or electric shock
resulting in death.
•
Always use two hands when operating the
extended-reach pruner. Hold the extended-
reach pruner with both hands to avoid loss
of control.
•
Always use head protection when
operating the extended-reach pruner
overhead. Falling debris can result in
serious personal injury.
Other safety information
•
Avoid Dangerous Environment – Don't use
products in damp or wet locations.
•
Don't Use In Rain.
•
Keep Children Away – All visitors should
be kept at a distance from work area.
•
Dress Properly – Do not wear loose
clothing or jewelry. They can be caught
in moving parts. Use of rubber gloves
6
and substantial footwear is recommended
when working outdoors. Wear protective
hair covering to contain long hair.
•
Use Safety Glasses – Always use face or
dust mask if operation is dusty.
•
Use Right Product – Do not use product for
any job except that for which it is intended.
•
Don't Force Product – It will do the job
better and with less likelihood of a risk of
injury at the rate for which it was designed.
•
Don't Overreach – Keep proper footing and
balance at all times.
•
Stay Alert – Watch what you are doing.
Use common sense. Do not operate
product when you are tired.
•
Store Idle Products Indoors – When not in
use, products should be stored indoors in
dry, and high or locked-up place – out of
reach of children.
•
Maintain Product With Care – Keep cutting
edge sharp and clean for best performance
and to reduce the risk of injury. Follow
instructions for lubricating and changing
accessories. Keep handles dry, clean, and
free from oil and grease.
•
Check Damaged Parts – Before further use
of the product, a guard or other part that
is damaged should be carefully checked
to determine that it will operate properly
and perform its intended function. Check
for alignment of moving parts, binding of
moving parts, breakage of parts, mounting,
and any other condition that may affect
its operation. A guard or other part that is
damaged should be properly repaired or
replaced by an authorized service center
unless indicated elsewhere in this manual.
Safety instructions for maintenance
WARNING:
attachment continues to rotate even
after the throttle/power trigger has
been released. If you have a
gasoline operated product, remove
the spark plug cap from the
spark plug. If you have a battery
operated product, remove the
battery from the product. Make sure
that the cutting attachment has
stopped completely before you do
maintenance on the attachment.
•
Make sure that the transport guard is
attached correctly to the cutting attachment
The cutting
2106 - 001 - 07.08.2023
Publicidad
