IPC Kosmic-H PW-H31 Manual De Instrucciones página 26

USING COLD WATER
It is suitable for removing light dirt or for rinsing operations
In the "ECO" mode, the pressure washer uses temperature
USING HOT WATER AND VAPOUR (If available)
For a correct use of the Hot Water and Vapour Mode (if avai-
lable), it's advisable to use the following temperatures:
- Light dirt: 30 - 50 °C:
- Cleaning Automobile or Machine Tools: 60 - 90 °C
- Debinding, Persistent greasy dirt: 100 - 110°C
- Facade cleaning, Sanitization of surfaces: up to 110 °C
With working temperature more than 95°C (203°F), the pressu-
re that indicates on the manometer must be
!
Danger
STOPPING THE CLEANER
1
2) Let the cleaner run with cold water only for at least 30
3
4
5) Disconnect the water cleaner from the mains electricity
supply via the Solenoid switch or by unplugging the plug from
6
English
60 °C Max
-
< a 32 bar
24
!
Warning
- Water cleaners with the "Total Stop" device should be con-
- When the water cleaner is not used, close the safety device
- Dry use of the water cleaner causes serious damage to
ADVICE ON USING DETERGENTS
!
Warning
This cleaner has been designed for use with the detergents
1) For environmental compatibility, we recommend a rea-
sonable use of detergents, according to the instructions on
2) From the range of recommended products, choose the
one most suited to the washing job to be done and dilute it
with water according to the instructions on the pack or in the
catalogue of the detergents most suited for the type of hot or
3
OPERATING PHASES FOR CORRECT CLEANING WITH
DETERGENTS.
1) Prepare the solution of detergent at the concentration most
2) Start the cleaner, activate the detergent suction control on
3) Rinse the whole surface well from top to bottom with hot or
4)
the detergent suction hose in a tank of clean water and let the
pump run for 1 minute with the dosing tap turned fully on and