Publicidad
Idiomas disponibles
Idiomas disponibles
3.8
Connecting 120/230 Volt version
3.8.1 Discharge
1. Slide the rubber sleeve (F)
over the outlet connection.
2. Fit the non-return valve (G)
using the hose clamp (H).
N.B.! The non-return valve
(G) must be fitted vertically
with the arrow upwards.
3.8.2 Hose connection
1. Cut the hose adapter to size.
2. Connect hose connector (Q)
to the toilet bowl drain (G).
3. Secure the hose connection
with hose clamp (H).
4. Fit the drain hose (ø 19 mm)
and secure it with hose
clamp (H).
3.9
Inlet and outlet connections
3.9.1 Outlet (general)
For the outlet pipe use a 19 mm
internal diameter hose (such as
the 'VETUS impermeable 'no
smell" sanitary hose'). Fix the
outlet with clamps.
3.9.2 Supply hose
The flexible water supply hose
attached to the motor housing
has a 3/4" connection.
Connect the flexible water sup-
ply hose to the ball valve on the
water supply pipe.
14
110128.11
3.10 Mounting the toilet bowl
Screw a retaining pin (B) onto
both threaded ends. The recess
in the side of the pin should face
outwards.
Keep 10 mm clearance to the
G
gasket.
F
H
Insert the plastic fixing plugs into the fixing holes at the back of the
toilet bowl.
The threaded holes of the plugs should face outwards.
H
Q
H
Insert the temporary mounting
aid.
G
Check all connections.
Place the toilet bowl on the
temporary mounting aid.
Tilt the toilet bowl over the
studs.
TEMPORARILY secure the toilet
bowl.
3.11 Testing
Turn the ball valve in the supply line fully open to obtain a good flush.
Press the long flush button and check that the cycle is performed
correctly.
Throw several sheets of toilet paper into the toilet bowl and perform
another long flush.
Carefully remove the bowl. Check all connections for tightness.
3.12 Final assembly
Using the temporary mounting aid, place the toilet bowl over the
threaded ends.
B
Installation manual HATO_C electric marine toilet
10 mm
Publicidad
