Ferroli BlueHelix HiTech RRT H Instrucciones De Uso, Instalación Y Mantenimiento página 305

BlueHelix HiTech RRT H
Accessing the electrical terminal block and fuse
After removing the front panel ( *** 'Opening the front panel' on page 320 ***) it is possible to ac-
cess the terminal blocks (M) and the fuse (F) following the directions given below (fig. 29 and
fig. 30). The terminals indicated in fig. 29 must be with voltage-free contacts (not 230V). The
arrangement of the terminals for the various connections is also given in the wiring diagram in
fig. 66.
10kOhm
1.8kOhm
Variable output relay card LC32 (optional - 043011X0)
The variable output relay LC32 consists of a small card with a switchover of free contacts (closed
means contact between C and NO). Operation is managed by the software.
For installation, carefully follow the instructions provided in the kit package and on the wiring dia-
gram of fig. 66.
To use the desired function refer to table 3.
EN
fig. 29
fig. 30
cod. 3541V484 - Rev 02 - 01/2024
F
305