Publicidad
Idiomas disponibles
Idiomas disponibles
If you are not completely familiar with automotive lift
maintenance procedures; STOP: Contact factory for
instructions. To avoid personal injury, permit only qualified
personnel to perform maintenance on this equipment.
• Always keep bolts tight. Check periodically.
• Always keep lift components clean.
• Always if oil leakage is observed, call local service
representative.
• Always if electrical problems develop, call local service
representative.
• Daily: Check cables and sheaves for wear. Observe for frayed
cable strands. Wipe cables with a rag to detect hard to see
small broken cable strands. Replace cables showing any
broken strands. Replace worn parts as required with genuine
Rotary parts.
Column Greasing:
Two post lifts must have grease applied to the columns. Columns need to be re-greased every 5000 cycles or six months,
whichever comes sooner. Grease columns with either TufOil Lighting grease, Sil Glide, or an equivalent grease.
Apply the grease to the columns by wiping on a thin layer and polishing with a rag. Only apply grease on surfaces of the
columns where the slider blocks make contact. Be careful not to apply too much grease, only a thin layer is needed, wipe
off excess.
MAINTENANCE INSTRUCTIONS
• Daily: Inspect adapters for damage or excessive wear.
• Monthly: Check equalizer cable tension. Adjust per lift
• Monthly: Lubricate arm pins with lubricating oil unless
• Monthly: Lubricate locking latch shafts. Push latch handle
• Every 3 Months: Check anchor bolts for tightness. Anchors
• Semi-Annually: Check fluid level of lift power unit and refill if
• Replace all caution, warning or safety related decals on the lift
52
Replace as required with genuine Rotary parts.
installation instructions. If there are no more threads available
for adjustment, replace the cable. Do not use washers to
stand off the nut to use previously used threads.
lubricating with grease or anti-seize on a semi-annual basis.
several times for oil to penetrate pivot points.
should be torqued to 65 ft/lbs (88 Nm).
required per lift installation instructions.
if unable to read or missing. Reorder labels from Rotary Lift.
Publicidad
