MSW Motor Technics MSW-GP-100 Manual De Instrucciones página 34

• Open the fuel valve by moving the fuel valve lever to the open position
indicated by the arrow (see fuel dispenser pictogram in the above
picture).
• (only if the engine is cold or stalls immediately after starting; cold ambient
conditions): Turn on the choke, i.e., move the choke valve to the "COLD"
position (see suction pictogram in the above image: blue arrow = choke
ON).
• Move the ignition switch to the "ON" position:
• Grasp the recoil starter handle and slowly pull away from the unit until
you feel resistance, then pull with a firm motion, keeping the handle in
your hand at all times even as it returns to the starting position. Repeat
this motion until the engine starts:
• Allow the engine to run with choke for about 1-3 minutes to reach
operating temperature.
• Then smoothly turn off the choke (set its lever gradually to "HOT"
position) and set the desired engine speed with the throttle lever -
moving the lever in the direction of the turtle pictogram decreases the
speed, and in the direction of the hare pictogram increases it:
EN