Dolmar TM-102.16 Manual De Instrucciones página 127

HOW TO USE THE MACHINE
5.4.7 U
NBLOCKING THE COLLECTOR CHANNEL
Cutting very tall or wet grass, particularly at too high speed, can cause the collector
channel to become blocked. Should this happen, it will be necessary to:
– stop forward movement immediately, disengage the blades and stop the engine;
– take off the grass-catcher or stone-guard;
– remove the accumulated cuttings, reaching them from the exit of the collector chan-
nel.
WARNING!
!
This job must only be performed with the engine turned off.
5.4.8 E
ND OF MOWING
When you have finished mowing, disengage the blades, lower the engine speed and
ride the machine with the cutting deck in the highest position.
5.4.9 E
ND OF WORK
Stop the machine, put the accelerator lever in the
«SLOW» position and turn off the engine by putting the
key into the «OFF» position.
When the engine is stopped, close the fuel stopcock (1)
➤
( if fitted).
WARNING!
!
To avoid backfire, put the acceler-
ator in the «SLOW» position for 20 seconds before
stopping the engine.
WARNING!
!
Always take out the ignition key if
leaving the machine unattended!
IMPORTANT
To keep the battery charged, do not leave the key in the «ON»
position when the engine is not running.
5.4.10 C
LEANING THE MACHINE
After each mowing, clean the outside of the machine, empty the grass-catcher and
shake it to remove residual grass and earth.
WARNING!
!
Always empty the grass-catcher and do not leave containers
full of cut grass inside a room.
29
EN
1