42
EN
6.5.2 D
,
ISMANTLING
REPLACING AND REMOUNTING THE BLADES
WARNING!
!
Always wear work
gloves when handling the blades.
WARNING!
!
Damaged or bent
blades must always be replaced;
never try to repair them! ALWAYS USE
MANUFACTURER'S GENUINE
REPLACEMENT BLADES BEARING
THE SYMBOL
! The blades differ,
are at 90° to one another, and are con-
tra-rotating. When installing them,
make sure that they are correctly
positioned by refering to the code
number marked on the outside of
each one.
1. Dismantling
1a = screw with right thread (loosen anti-
clockwise)
1b = screw with left thread (tighten clock-
wise)
2. Original spare parts
Only the following pairs of blades can be
used on this machine:
Mod.102: 2b 82004341/1
Mod.102: 2b 82004348/0
Mod.122: 2b 82004350/0
3. Remounting
Check that the concave part of the cushion
disc (3) presses against the blade.
Remount the shaft hubs (4), making sure
that the keys (5) are securely lodged in
place.
4. Tightening the screws
1a = screw with right thread (tighten clock-
wise)
1b = screw with left thread (tighten anti-
clockwise)
Tighten with a torque wrench calibrated
to 40-45 Nm.
1
2
2b
3
82004340/1 2a
82004347/0 2a
82004349/0 2a
1b
2b
4
1b
MAINTENANCE
2b
1a
1b
2a
90°
5
1a
3
2a
2a
4
1a