During normal use
environmental circumstances.
The installation's owner must ensure that the instructions of this user
manual are followed.
The safety protection devices present may not be removed.
The correct operation and safety of the system can only be guaranteed
if the maintenance is carried out correctly and on time as prescribed.
If any work has to be carried out on the installation, the installation must
be disconnected and locked from the power supply.
During operation several parts of the machine will be very hot. The user is
responsible for carry out precautions to avoid injuries.
During operation hot water may splash. Take precautions to avoid injuries.
It is compulsory to use personal protection to avoid injuries.
Only authorised persons may carry out work on the electrical
installation.
Keep electrical control cabinets closed to prevent contact with high
voltage parts.
Ensure through internal procedures and surveillance that all applicable
power supplies are switched off.
The installation may not be used during inspection and maintenance
and the main switch needs to be turned off and blocked.
For repairs or maintenance to the electrical circuit, switch off the main
power supply and block it.
Never carry out any welding work on the installation without
disconnecting the cable connection to the electrical components first.
Never use the power supply of the control cabinet to connect other
machines.
All electrical connections have to be connected to the terminal strips
according to the electrical diagram.
Before starting up the installation, make sure that no work is being carried
out on the installation and it is ready for use.
Unauthorised persons are not allowed to enter the installation area.
Ensuring this is the task of the machine operator(s).
Contact the service engineer of your technical department or dealer
immediately if changes like boiling of the water, unusual vibrations or
unusual noise appear.
9