Bowers & Wilkins CM1 S2 Manual De Instrucciones página 5

1. Unpacking
CM1 S2
CM5 S2
CM6 S2
Carton Contents
Check in the carton for:
2 Foam plug
8 Self-adhesive rubber supporting feet
1 Tweeter mesh removal tool (CM1 S2 and CM5 S2 only)
1 Tweeter grille removal tool (CM6 S2 only)
Environmental Information
This product complies with international directives, including but
not limited to:
i. the Restriction of Hazardous Substances (RoHS) in
electrical and electronic equipment,
ii. the Registration, Evaluation, Authorisation and restriction of
CHemicals (REACH)
iii. the disposal of Waste Electrical and Electronic Equipment
(WEEE).
Consult your local waste disposal authority for guidance on how
properly to recycle or dispose of this product.
Speaker Installation
The speaker is primarily designed to be mounted on a dedicated
floor stand (FS-CM S2), but may be placed on a shelf if preferred.
However, it should be noted that this offers less flexibility to
optimise the speaker's performance. If shelf placement must be
used, we recommend using the foam bung inserts (supplied) to
optimise port performance (see Section 4: Fine-Tuning).
In both installation cases, the speakers' tweeters should be
approximately at ear height at your usual listening position.
Note: If using a shelf, ensure that it is strong enough to
properly support the weight and fit the 4 rubber supporting
feet to the underside of the speaker.
5