Publicidad
Idiomas disponibles
Idiomas disponibles
,:_;!i!IiiiKARAOKEI;;_,
2
KARAOKE
A microphone
(not supplied)
can be connected
to this unit,
allowing
you to sing along to music sources.
Use a microphone
with mini plugs (03.5 mm, 1/8 inch).
1 Connect your microphone to the MIC jack.
MIC 1
2 Press one of function
to select the source to be
mixed, and play the source.
3 Adjust the volume and tone of the source.
4 Turn the MIC VOLUME
control
to adjust
the
microphone volume.
To record microphone sound mixed with source sound
Follow the procedure for recording from the sound source (see
page 12).
SYNCHRO DUBBING cannot be used for mixing recording.
When not using the microphone
Set the microphone volume to MIN and remove the microphone
from the MIC jack.
• If a microphone
is held too near the speakers,
a howling sound
may be produced.
In this case, hold the microphone
away from
the speakers,
or decrease
the microphone
volume.
• If sound through the microphone
is extremely
loud, it may be
distorted.
In this case, decrease
the microphone
volume.
Recommended
microphone
The use of unidirectional type microphone is recommended to
prevent howling. Contact your local Aiwa dealer for details.
VOCAL FADER/MULTIPLIEX
FUNCTIONS
This unit can use discs or tapes as Karaoke
sources.
Use the vocal fader function
for ordinary
disc,s or tapes.
Use the multiplex
function
for multi audio discs or tapes.
Press KARAOKE repeatedly to select the vocal fader er
multiplex function.
_:_
Each time KARAOKE is pressed, one of these functions is
selected cyclically.
-->
_.._-_
......
_
_-, ,,.,..L _;_:--
®
®
(b
®
®
®
Vocal Fader
The singer's voice becomes softer than the accompaniment.
Auto Vocal Fader
The singer's
voice becomes
softer
only while there
is audio
input through
a microphone.
Multiplex
The sound on the left channel is heard from both speakers
and the sound on the righl channel is muted.
To hear the sound on the right channel, see below.
Auto Multiplex
The sound on the left channel
is heard from both speakers,
and the sound on the right channel
is muted only while there
is audio input through
a microphone.
To hear the sound on the right channel,
see below.
(_) Cancel
To change the time lag setting in Auto Vocal Fader or
Auto Multiplex function
The muted original singer's voice can be turned faster to the
normal level.
When Auto Vocal Fader or Auto Multiplex is Selected, "A-VF" or
"A-MPX" is displayed for 3 seconds and changes to the selected
function name. After the selected function name isdisplayed,
pressing KARAOKE until "FAST" is displayed.
To return to the initial setting, select ,SLOW.
When the power is turned off, SLOW is restored.
To change the audible channel in Multiplex function
When Multiplex is selected, "MPX -U' is.displayedfor 3 seconds
and changes to the selected function name. After the selected
function name isdisplayed, keeppressing KARAOKE until"MPX-
R" is displayed.
To return to the initial setting, select MPX-L.
When the power is turned off, MPX-L is restored.
• The Karaoke functions may not operate correctly with the
following kinds of CDs or tapes.
- Those with monaural sound
- Those recorded with strong echoes
- Those with the vocal part recorded on the right or left side of
the sound width
• While the Karaoke function is on, the sound is output as
monaural.
- When the function is changed, the Karaoke function is canceled.
ENGLISH
16
Publicidad
