Publicidad
Idiomas disponibles
Idiomas disponibles
--ENTER
--MULTI
JOG
4 Select the duration for the timer-activated
period
with <1<1 DOWN or IH_ UP, then press II SET.
5
The durationfor the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
Prepare
the source.
To listen to a CD load the disc to be played first on tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.
Press POWER
to turn the unit off after adjusting
the volume
and tone.
(_) remains on the display after the power is turned off (timer
standby mode).
The unit can be turned
on at a specified
time every day with the
built-in
timer.
Preparation
Make sure the clock is set correctly.
1 PressTIMER
repeatedly
to display
_), then press
II
SET within
6 seconds.
is displayed and the hour flashes.
®
=..,
If you press II SET after 6 seconds, another operation may
start.
2 Designate
the hour of the timer-on
time
by
pressing <1<1 DOWN or _
UP, then press II
SET.
Repeat to designate the minute of the timer-on
time.
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
The volume level is automatically set to 20 when the power is
turned off with the volume level set to 21 or more.
To check the specified time and source
Press TIMER. The timer-on time, the selected source name and
the duration for the timer-activated period are displayed for 4
seconds.
To cancel timer standby mode temporarily
Press TIMER repeatedly until E) or _)REC disappears on the
display.
To restore the timer standby mode, press TIMER once or twice
to display _) or _)REC.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning the power off, carry out step 5 to prepare the
source, and adjust the volume and tone.
• Timer playback and timer recording will not begin unless the
power is turned off.
• Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
After you designate
the timer-on time, one of the source names
flashes
on the display.
3 Press _
DOWN
or _
UP to select
a source,
then press II SET.
• If TUNER (AM or FM) is selected, the band cannot be
selected in this step.
TIMER RECORDING
Timer recording is applicable for TUNER and VIDEO/AUX (with
an external timer) sources only.
Press TIMER repeatedly until _)REC appears, then press I I
SET within 6 seconds. Carryout the steps of "SETTING THE
TIMER" from step 2 and insert the tape to be recorded on into
deck 2 after step 5.
* ENTER
is a/so available
instead
of H SET.
* MULTI
JOG is also available
instead
of <f,<f and _.
19
ENGLISH
Publicidad
