Publicidad
Idiomas disponibles
Idiomas disponibles
3. Lay the chain saw on a firm, flat
surface, so that the oil-tank cap is
facing upwards. Flip the tab of the
oil-tank cap and rotate the oil-tank
cap counterclockwise to remove it
(Fig. 13).
4. Carefully pour the bar and chain oil
into the tank. Be careful not to let
the oil spill from the opening. Fill to
the bottom of the fill neck. Wipe off
any excess oil.
5. Replace and tighten the cap, place the saw upright, and view the level through
the oil-inspection window. Oil should fill the window.
NOTICE:
◾
Use EGO AOL3200 or AOL1000 bar and chain oil for best results. They are
specifically designed to provide low friction and faster cuts.
◾
Never use oil or other lubricants not specifically designed for use on the bar and
chain. This can lead to a clogged oil system, which may cause premature wear of
the bar and chain.
◾
Check the oil level frequently and fill when the oil level falls below the minimum
mark. Never operate the chain saw if the oil is not visible.
◾
Do not use dirty, used or otherwise contaminated oil. Damage may occur to the
bar or chain.
◾
It is normal for oil to seep from the saw when it is not in use. To prevent seepage,
empty the oil tank after each use, and then run the saw for one minute. When
storing the tool for a long period of time, be sure the chain is lightly lubricated;
this will prevent rust on the chain and bar sprocket.
◾
To preserve natural resources, please recycle or dispose of oil properly. Consult
your local waste authority for information regarding available recycling and
disposal options.
28
56-VOLT CORDLESS COMMERCIAL 20" CHAIN SAW — CSX5000/CSX5000-FC
13
Oil-Tank
Cap
Tab
Minimum Mark
Publicidad
