EGO Commercial CSX5000 Manual Del Operador página 35

LED HEADLIGHT (Fig. 19)
The LED headlight is located in the front
of the chain saw housing. The headlight
provides illumination for increased
visibility and features 2 brightness levels.
To turn on the headlight, press the
headlight/Bluetooth button (Fig. 17) one
time. The headlight will turn on in low
brightness level and the headlight icon
will appear on the LCD screen.
Press the headlight/Bluetooth button again to switch to high brightness level and the
headlight icon
To turn off the headlight, press the headlight/Bluetooth button the third time. The
headlight icon will disappear from the LCD screen.
PREPARATION FOR CUTTING
Refer to section "SAFETY INSTRUCTIONS" earlier in this manual for appropriate safety
equipment.
Work Area Precautions
◾
Cut only wood or materials made from wood; do not cut sheet metal, plastics,
masonry, or non-wood building materials.
◾
Never allow children to operate the chain saw.
◾
Allow no person who has not read this Operator's Manual or received adequate
instructions for the safe and proper use of this chain saw to use this chain saw.
◾
When felling a tree, keep everyone – helpers, bystanders, children, and animals
– a safe distance away from the cutting area. During felling operations, the safe
distance should be a least twice the height of the largest trees in the felling area.
During bucking operations, keep a minimum distance of 15 feet (4.5 m) between
workers. Trees should not be felled in a manner that would endanger any person,
strike a utility line, or cause any property damage. If a tree does make contact
with a utility line, stay clear of the tree and the line and notify the utility company
immediately.
◾
Always cut with both feet on solid ground to prevent being pulled off balance.
◾
Do not cut above chest height, as a saw held higher is difficult to control against
kickback forces.
56-VOLT CORDLESS COMMERCIAL 20" CHAIN SAW — CSX5000/CSX5000-FC
will appear on the LCD screen (Fig. 17).
19
LED Headlight
35