AEG IAE84883FB Manual De Instrucciones página 12

Symbols useful for display navigation
To scroll up / down the instructions on the
display.
To activate / deactivate the options.
To close the pop-up window.
To cancel a setting.
5.2 First connection to the mains
When you connect the hob to the mains you
have to set Language, Display Brightness
and Buzzer Volume.
You can change the setting in Menu >
Settings > Setup. Refer to "Daily use".
5.3 Food Sensor calibration
Before you start using the Food Sensor you
need to calibrate it, to ensure that the
temperature readings are correct.
Once the Food Sensor is calibrated properly,
it measures the temperature at the boiling
point with the tolerance range of + / - 2 °C.
Follow the procedure when:
• you install the hob for the first time;
• you move the hob to a different location
(change of altitude);
• you replace the Food Sensor.
Use a pot with the bottom
diameter of 180 mm and fill it
with 1 - 1,5 l of water. Do not put
salt into the water, this may
affect the procedure.
Make sure that the power level is
set to 2000 W at a minimum.
1. To calibrate or re-calibrate the function,
put the Food Sensor on the rim of a pot.
Fill the pot with cold water, at least up to
Assisted Cooking
12 ENGLISH
the minimum level mark, and place it on
the left front cooking zone.
2. Touch .
Select Settings > Food Sensor > Calibration
from the list.
3. Touch Calibrate.
Follow the instructions on the screen.
To leave the Menu, touch
of the display, outside of the pop-up window.
5.4 Food Sensor pairing
Originally, your hob is paired with the Food
Sensor upon delivery.
If you replace the Food Sensor with a new
one, you need to pair it with your hob.
1. Touch .
Select Settings > Food Sensor > Pairing from
the list.
2. Touch Forget to disconnect the previous
Food Sensor.
3. Touch Pair next to the cooking zone.
A pop-up window appears.
4. Enter the five-digit code engraved on
your new Food Sensor, using the number
pad.
5. Touch OK to confirm.
Your Food Sensor is now paired with the
hob.
Always calibrate the Food Sensor after
pairing.
To leave the Menu, touch
of the display, outside of the pop-up window.
5.5 Menu structure
Touch to access and change the settings
of the hob or activate some functions.
To leave the Menu, touch
of the display, outside of the pop-up window.
To navigate through the Menu use or .
The table shows the basic Menu structure.
or the right side
or the right side
or the right side