Replacement Of Belts - GASPARDO FBR Plus Serie Empleo Y Mantenimiento

ENGLISH

4.2.2 REPLACEMENT OF BELTS

- Unscrew the screws (M, Fig. 47) and remove the protective
casing.
- Loosen the belt tensioner completely (N, Fig. 47).
- Replace the worn belts with new ones.
- Put these at the optimum tension using the belt tensioner. Belt
play should not exceed 2 centimetres.
- Put the protective casing back in position and fi x it in place with
the screws (M, Fig. 47).
4.2.3 REPLACEMENT OF PULLEYS
Notes for replacement of pulleys, if necessary.
- Unscrew the screws (M, Fig. 47) and remove the protective
casing.
- Loosen the belt tensioner completely (N, Fig. 47).
- Remove the belts.
To replace the driving pulley (O, Fig. 48), turn it clockwise; vice
versa, turn the driven pulley (P, Fig. 48) counterclockwise.
TABLE APPROXIMATE FOR CHOICE OF THE CUTTING BAR
TYPE OF THE GROUND
Normal
Level
Stny fi eld
Normal
Hill
Stny fi eld
Normal
Mountain
Stny fi eld
Normal Section
(SN)
42
USE AND MAINTENANCE
Dry and lignifi cated
(gramineae)
DNE - SD/SN
DSE - SD/SN
DNE - SD/SN
DSE - SD/SN
DNE - SD/SN
DSE - SD/SN
Self sharping double section
(SD)
N
Fig. 48
TYPE OF THE FORAGE
Humid, packed and
low (cat coat)
DNE - SD
DSE - SD
DNE - SD
DSE - SD
DNE - SD
DSE - SD
Replaceable tooth
(DSE)

M
O
Humid and packed Big and high (forage
(Lucerne-Clover) of the sorghum, corn)
DNE - SN
DSE - SN
DNE - SN
DSE - SN
DNE - SN
DSE - SN
cod. G19503010
Fig. 47
P
DNE - SN
DSE - SN
DNE - SN
DSE - SN
DNE - SN
DSE - SN
Tooth normal
(DNE)