Publicidad
Idiomas disponibles
Idiomas disponibles
be cut in time to prevent the occurrence of danger.
• Don't put hands or any objects into the air inlets or outlets. This may
cause personal injury or damage to the unit.
• Please note whether the installed stand is firm enough or not. If it is
damaged, it may lead to the fall of the unit and cause the injury.
• Don't block air inlet or air outlet. Otherwise, the cooling or heating
capacity will be weakened, even cause system stop operating.
• Don't let the air conditioner blow against the heater appliance. Otherwise
it will lead to incomplete combustion, thus causing poisoning.
• The appliance shall be installed in accordance with national wiring
regulations. An earth leakage breaker with rated capacity must be
installed to avoid possible electric shocks.
• Don't open the windows and doors for long time when the air
conditioner is running. Otherwise, the cooling or heating capacity will
be weakened.
• Don't stand on the top of the outdoor unit or place heavy things on it.
This cloud cause personal injuries or damage the unit.
• Don't use the air conditioner for other purposes, such as drying clothes,
preserving foods, etc.
• Don't apply the cold air to the body for a long time. It will deteriorate
your physical conditions and cause health problems.
• Set the suitable temperature. It is recommended that the temperature
difference between indoor and outdoor temperature should not be too
large. Appropriate adjustments of the setting temperature can prevent
the waste of electricity.
• If your air conditioner is not fitted with a supply cord and a plug, an
anti-explosion all-pole switch must be installed in the fixed wiring and
the distance between contacts should be no less than 3.0 mm.
Fuse Type: T3.15AH250V, the electricity passing through the fuse cannot
be higher than 3.15A. For the air conditioner permanently connected to
an outlet, equip the line with a power switch. The current switch must be
single-pole, with a distance between the contacts greater than 3 mm and
a residual nominal value not greater than 30 mA. The power supply circuit
must have a leakage protection device and an air switch whose rated
capacity should be greater than 1.5 times the maximum current.
V 11/23
35
Publicidad
