AERMEC FCWI 232V Manual De Instrucciones E Instalación página 42

ELECTRICAL CONNECTIONS
FCWI233V
FCWI232V
FCWI23VL
FCWI333V
FCWI332V
FCWI33VL
WA R N I N G: check that the power supply is
disconnected before carrying out any procedures
on the unit.
The unit must be connected directly to an electrical
connection or an independent circuit.
Power with a voltage of 220-240V (±10%).
To protect the unit against short circuits, fit an
omnipolar thermal-magnetic switch (max. 2A
250V - CIRCUIT BREAKER) on the power line, with a
minimum contact opening distance of 3mm.
ELECTRICAL CONNECTIONS TO THE FAN COILS
FCWI233V - FCWI232V - FCWI23VL - FCWI333V - FCWI332V - FCWI33VL
FCWI433V - FCWI432V - FCWI43VL - FCWI533V - FCWI532V - FCWI53VL
IG
Cable section
WARNING
The unit must be earthed in a reliable manner; an incorrect connection may cause electric shock or fires.
42
Frame grille
Control board
Control board seat
Base
Cable clamp
FCWI_2V FCWI_3V FCWI_VL
FCWI433V
FCWI432V
FCWI43VL
FCWI533V
FCWI532V
FCWI53VL
The electricity supply cable must be of the H07 V-K or N07
V-K type, with 450/750V insulation if inserted in a tube or
duct. For installations with exposed cable, use cables with
dual insulation (H5VV-F type).
For all the connections, respect the wiring diagrams
supplied with the device.
Ensure that the wiring complies with the laws and
standards in force, and with the instructions in this
manual.
All the parts and materials supplied on site must comply
with the local laws and regulations.
Microprocessor
control with electronic
board
Control board
Connecting cable
Microprocessor
control with electronic
board
Control board
Connecting Cable
2A
2
1.5mm
Frame grille
Control board
Control board seat
Base