Publicidad
Idiomas disponibles
Idiomas disponibles
Bolt-down instructions... continued
Move the safe aside to clear both marked spots for drilling.
5
6
Replace the safe in the desired position, with the holes in
7
the safe aligned with those in the floor.
8
F
F
F
NOTE: • The safe should not be bolted to a wall, this will compromise the fire rating.
Drill holes through the feet only. DO NOT drill through the back or sides.
• Bolting/unbolting the unit is at the consumer's expense and discretion.
• SentrySafe is not responsible for any costs incurred if the unit is to be replaced.
Not all SentrySafe products come with a bolt-down kit.
Please go to www.sentrysafe.com to learn more about the recommended hardware for
your safe.
Bolting Down Your Safe
Drill into the floor:
For wood: Using the
A
(64 mm) deep in each marked spot.
For masonry: Using the
B
(64 mm) deep in each marked spot. Install a masonry
anchor in each hole.
Securing the safe:
For wood: Pass each lag screw through a washer,
A
then through the safe and into a hole. Tighten with
the wrench.
For masonry: Pass each lag screw through a washer,
B
then through the safe and into a masonry anchor.
Tighten with the wrench. Place masonry anchors into
the holes in the floor.
12
⁄
" drill bit, drill a hole 2
9
32
⁄
" drill bit, drill a hole 2
3
8
⁄
"
1
2
⁄
"
1
2
Publicidad
