Publicidad
Idiomas disponibles
Idiomas disponibles
2
3
NOTE: • Make sure the handle is rotated all the way up in the horizontal position before
unlocking the safe.
• If you exert too much force on the handle, the handle will move without moving the
bolts. If not when this happens, you will hear a 'click.' DO NOT be alarmed. This feature
is designed to protect the bolts from being over powered by force. If this occurs, simply
exert force in the opposite direction (lifting up) until the handles 'clicks' back into place
and repeat steps 1-3 to open your safe.
• Delay mode will occur if three consecutive invalid entries have been tried. Red LED will
blink on and off to let you know the safe is in delay mode. This will cause the system
to shutdown for two minutes. DO NOT remove the batteries to restart the system it will
only increase the length of time for the system shutdown.
Locking your safe
1
2
Enter the 5 digit factory code found on the back of the
A
owner's manual.
NOTE: You may have to lift the handle while entering the
combination.
A green light will indicate the code is correct. You will have
B
4 seconds to turn the handle to unlock your safe.
Rotate the handle downward to open the door.
This may take a limited amount of force if you have a water-
resistant safe.
Close the door and pull the handle upward until the handle is
horizontal.
For water-resistant units, additional pressure to the front,
left side of the door may need to be applied prior to rotating
the handle.
FOR DUAL KEY/ELECTRONIC LOCKS ONLY, insert key into
the lock, turn to the 'locked' position, then remove the key.
NOTE: If your safe does not appear to be working properly,
please check to make sure you are using NEW
alkaline batteries before contacting SentrySafe
Customer Service.
7
Publicidad
