Publicidad
Idiomas disponibles
Idiomas disponibles
14
Sentry Tube Heaters
Installing Reflectors & Supports
Refer to Fig. 8 for the following instructions:
1. Attach end cap to one end of the first reflector. Use
A
the 4 U-clips to secure it to the relector.
2. Slide this end of the reflector through the hanges until
it is about 1 to 2 inches away from the burner box.
3. Connect the next reflector to the previous one using
the dimpled connector strips. See detail B below.
FIG. 8
OVERHEAD
A
DETAIL A
DETAIL A
REFLECTOR USING CONNECTION STRIPS:
• Insert a connection strip halfway into the folded channel
at both sides of a reflector, at the end without flanges.
• Slide this end of the reflector through the hanger and
push it firmly into the folded channels of the reflector at
the burner box.
• The unflanged end of the reflector will overlap the
flanged end of the adjacent reflector.
Owner's Manual • Sentry
B
B
CONNECTOR STRIP
(DIMPLES UP)
DOTTED LINES:
INDICATE CONNECTOR
WITHIN CHANNEL
DETAIL A
4. Repeat Steps 3 for remaining reflectors.
5. Install a support hanger at the end of the reflector
nearest burner box and at the end of the last
reflector. Install the remaining hangers evening
throughout the length of the tube. Do not install
a support directly next to a hanger of the same
reflector.
6. Attach the remaining end cap to the last reflector
with the U-clips.
OVERHEAD
B
DETAIL B
DETAIL B
45° ANGLE
DETAIL B
Publicidad
