Cleaning The Filter - GUTMANN Nivel 8000 ML Instrucciones De Uso

CHANGE / CLEAN FILTER

Cleaning the filter

Empty the collection tray (14) and filter container (16) regularly (every 14 days) or more
frequently if necessary, wipe them out and rinse them under hot water.
Condensation filter (4), collecting tray (14) and grease filter (17) can be cleaned in the
dishwasher.
After approx. 40 operating hours, the display (1) on the control panel flashes to indicate
that the grease filter has been cleaned.
After cleaning, reinsert the grease filter and reset the grease filter display by RESET.
The cooker hood must be in "ON" mode. For this symbol "A" for min.
Keep pressed for 3 seconds until symbol "1" no longer flashes.
The manufacturer does not accept any liability for possible
discolouration caused by the use of aggressive detergents.
Attention: Do not use multi-phase cleaners. Do not use the
filter in a commercial dishwasher. A cleaning with aggressive
cleaning agents such as petrol, acetone, trichloroethylene etc.
can lead to damage!
Cyclic change of the activated carbon fine dust filter
As cleaning is not possible, it should be replaced after 12 months. There is a need for
premature replacement if the cleaning performance of the filter decreases ( noticeable
by the fact that the extractor hood no longer provides the full extraction performance, or
the room air quality is no longer acceptable ).
Insert filter
- Open lid of the filter container (16).
- Insert grease and activated carbon filter
(17+18) in the illustrated arrangement.
- Place the filter container (16) in the
drawer (3)
- Insert collecting tray (14).
- Insert the condensation filter (4)
into the in the position shown in
the illustration.
OPERATING INSTRUCTIONS
EN
max. 55°C
33