Publicidad
Idiomas disponibles
Idiomas disponibles
Repair
■
Check the oil level.
■
Tie up long hair and remove jewellery.
■
Do not wear loose clothing.
■
Wear sturdy, non-slip shoes.
■
Do not change the basic setting of the engine
or over-rev.
■
Keep the safety distance when starting.
■
Switch off the engine and allow to cool down
before removing the tank cap.
■
Switch off the engine, allow it to cool and re-
move the spark plug cable before checking,
cleaning or working on the machine or en-
gine.
■
Wait until the engine has cooled down suffi-
ciently before touching the cylinder ribs and
protective housing.
■
Do not rotate the engine without a spark plug.
5.1
Stop the engine and switch off
NOTE
Observe the operating instructions for
the lawnmower.
NOTE
The engine has a fixed gas setting.
Speed control is not possible.
Starting the engine
CAUTION!
Risk of injury!
Danger of kickback: The starter cable
can return faster to the engine than the
cable can be released.
■
Anticipate a sudden jolt when the
starter cable has been pulled.
■
Pull the starter cable (01/4) out briskly,
and then allow it to wind back in slowly.
With the motor running:
■
Do not place your hands and feet close to
any rotating parts.
■
Keep flammable objects from the exhaust
and the cylinder area.
■
Allow the exhaust, cylinder and cooling vanes
to cool down before contact.
Switching off the engine
■
Observe the operating instructions for the
lawnmower.
495587_a
6 REPAIR
WARNING!
Risk of injury during repair work
Improper repairs can lead to serious in-
juries and damage to the appliance.
■
Repair work may only be carried out
by ISEKI service centres or autho-
rised specialist workshops.
■
Only original spare parts are allowed.
7 MAINTENANCE AND CARE
WARNING!
Risk of injury
Inadvertent switching on of the engine
can lead to serious injuries.
■
Before setting, maintenance and re-
pair work, always switch off the en-
gine and secure against being
switched on again.
■
Regular maintenance is essential for safety
and maintaining performance.
■
Observe the maintenance schedule.
■
For use under more demanding conditions,
more frequent maintenance is required.
1. Before all maintenance and cleaning work:
Remove spark plug connector (01/5) from the
spark plug.
2. Perform the maintenance and cleaning work
described in this section according to the
maintenance schedule.
3. After maintenance and cleaning work: Reat-
tach the spark plug connector(01/5) to the
spark plug.
7.1
Angling the engine (07)
1. Angle the engine so that the carburettor/air
filter (07/1) points upwards.
7.2
Cleaning the air filter (05)
■
Clean the air filter regularly.
■
Replace the air filter if damaged.
1. Remove the air filter cover (05/1) by pressing
the locking tabs (05/2) and removing the air
filter cover.
2. Remove the filter (05/3) and knock it out
against a hard surface until the dirt has been
removed. Do not brush out!
3. Reinstall the filter.
21
Publicidad
