BRASSELER USA EndoPro Ai1 Manual De Instrucciones página 12

Connect the measuring wire to the motor handpiece. Line up the measuring
wire plug with the notch on the back of the motor and push it all the way in.
Connect the file clip plug into the socket (black) on the measuring wire.
Connect the lip hook to the socket (white) on the measuring wire
Warnings:
Connect the lip hook to the socket (white) on the measuring wire. Otherwise,
the function of root canal preparation and root canal length measurement
cannot be used together.
2.7 Installation and removal of disposable isolation sleeves
2.7.1 Installation
Before each use of the handpiece and after the handpiece is cleaned and
disinfected,put on a disposable isolation sleeve. Take the isolation sleeve out
of the isolation sleeve box, then insert the isolation sleeve into the motor
handpiece from the thin end of the handpiece, and install the isolation sleeve
until there is no obvious wrinkle.
After installing the disposable isolation sleeve, wrap the barrier film around
the handpiece surface. After that, clean and disinfect the surface of the
handpiece. Refer to Chapter 6.3 for cleaning and disinfection procedures.
10