Makita RM350D Guía De Preparación página 26

a) 100 cm or more b) 50 cm or more
Installing the guide wire
1. Cut the boundary wire loop (eyelet) made in advance at the boundary wire - guide wire connection site.
► Fig.14: 1. Boundary wire
2.
Insert the guide wire to the center port and the boundary wires to the left and right ports of the three connection ports of the supplied coupler.
► Fig.15: 1. Coupler 2. Boundary wire 3. Guide wire
NOTE: Insert all three wires as far as they will go.
3. Clamp the coupler with pliers to fix the wires.
► Fig.16
4. Drive the pegs on both sides of the connecting point using a plastic hammer.
► Fig.17: 1. Peg
NOTE: Make sure that the connection between the guide wire and the boundary wire is approximately 90°.
5. Install the guide wire by driving the pegs up to the charging station using a plastic hammer.
• Drive the pegs at intervals of about 1 m, but use a narrower interval if the guide wire floats.
• When making a curve, install the guide wire at an angle about 135°.
• Install the guide wire in a straight line for 2 m or more in front of the charging station.
• For other guide wire installation conditions, refer to "Guide wire installation conditions" (page 25).
► Fig.18: 1. Charging station 2. Guide wire
► Fig.18: a) 2 m or more b) About 135°
6. When finished installing the guide wire up to the charging station, pass the guide wire to the back of the charging station through the hole at the
bottom of the charging station tower.
► Fig.19: 1. Hole 2. Tower
NOTE: Cut the guide wire so that about 30 cm or more is left extending from the back of the charging station.
7.
Insert and fix the guide wire in the groove in the center of the station base.
► Fig.20: 1. Groove 2. Station base
8. Attach a connector to the tip of the guide wire.
NOTE: Refer to page24 for how to attach the connector.
9.
When installing a second guide wire, repeat steps 1 through 8.
NOTE: For details of connection with the charging station, refer to "Connecting the Wires to the Charging Station" (page 27).
Image
(a)
(b)
The width of the work area should be at least 150 cm or more. Make sure that the
space on the left side of the guide wire is wide because the Robotic Mower passes
through the left side of the guidewire and returns to the charging station.
Do not let the guide wire cross the boundary wire.
26 ENGLISH
Condition