Toro TimeCutter 5000 Manual Del Operador página 47

8. Install the washer and hairpin cotter
9. Repeat steps 6 through
the machine.
10. Check the side-to-side level again; repeat this
procedure until the measurements are correct.
11. Continue leveling the mower deck by checking
the front-to-rear blade slope; refer to
the Front-to-Rear Blade Slope (page
Adjusting the Front-to-Rear Blade
Slope
1. Rotate the adjustment nut in the front of the
mower (Figure 65).
1. Adjusting rod
2. Adjusting block
2. To raise the front of the mower deck, tighten the
adjustment nut.
Figure 64
(Figure
8 for the other side of
Checking
43).
Figure 65
3. Adjustment nut
3. To lower the front of the mower deck, loosen the
adjustment nut.
4. After adjustment, check the front-to-rear slope
again, continue adjusting the nut until the front
blade tip is 1.6 to 7.9 mm (1/16 to 5/16 inch)
lower than the rear blade tip; refer to
the Front-to-Rear Blade Slope (page
5. When the front-to-rear blade slope is correct,
check the side-to-side level of the mower deck
again; refer to
(page 43).
g294195
Removing the Mower Deck
64).
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Lower the height-of-cut lever to the lowest
position.
4. Remove the hairpin cotter from the front support
rod, and remove the rod from the deck bracket
(Figure 66).
1. Front support rod
g294471
5. Carefully lower the front of the mower deck to
the ground.
6. On 1 side of the machine, remove the washer
and hairpin cotter from the deck pin
45
Checking the Side-to-Side Level
Figure 66
2. Deck bracket
(Figure
Checking
43).
ARK
g366001
67).