Publicidad
Idiomas disponibles
Idiomas disponibles
INDOOR UNIT INSTALLATION
Step2: Install the hooks
2.1 Ensure to meet the minimum installation dimension requirements as step 1,
Take out the installation cardboard and fix it on the wall and adjust the cardboard to a horizontal
state .
2.2 Mark out the screw hole positions on the wall according to the holes on the cardboard.
2.3 Put down the install cardboard and drill holes in the marked positions with drill.
2.5 Insert expansion rubber plugs into the holes, then fix the two hooks on the wall at the positions
Hole1 and Hole 2.
Step3: Drill Wall Hole
A hole in the wall should be drilled for refrigerant piping ,the drainage pipe, and connecting cables.
3.1 Determine the location of wall hole(Left, Right, or below the bottom of console), the wall hole top
shall be lower than the bottom surface of console to prevent water leakage.
3.2 The hole should be have a 65mm diameter at least and a small oblique angle to facilitate drainage.
3.3 Drill the wall hole with 65mm core drill and with small oblique angle lower than the indoor end
about 5mm to 10mm.
3.4 Place the wall sleeve and wall sleeve cover(both are optional parts) to protect the connection parts.
Caution:
When drill the wall hole, maker sure to avoid wires, plumbing and other sensitive components.
The hole top shall be lower than the
bottom surface of console
Indoor
16
Wall sleeve Cover
(Optional)
Wall sleeve
(Optional)
5-10mm
Small bolique angle
Outdoor
Publicidad
