Publicidad
Idiomas disponibles
Idiomas disponibles
INDOOR UNIT INSTALLATION
Step7: Wrap Piping and Cable
After the refrigerant pipes, connecting wires and drainage hose are all installed, in order to save
space, protect and insulate them, it must be bundle with insulating tape before passing them through
the wall hole.
7.1 Arrange the pipes ,cables and drainage hose well as the following picture.
Connecting wiring
Insulation tape
(I)
Make sure the drainage hose is at the bottom.
Note:
(II) void crossing and bending of parts.
A
7.2 Using the insulating tape wrap the refrigerant pipes, connecting wires and drainage hose
together tightly.
Step8: Mount Indoor Unit
8.1 Slowly pass the refrigerant pipes, connecting wires and drainage hose wrapped bundle through
the wall hole.
8.2 Hang the top of indoor unit on the two hooks.
8.3 Apply slight pressure to the left and right sides of the indoor unit, make sure the indoor unit is
hooked firmly.
8.4 Use a long screwdriver to fix the 4 screws .
Refrigerant piping
Drainage hose
Fix four screws
20
Publicidad
