MSW -PG-100 Manual De Instrucciones página 34

2) Connecting Electric Devices
AC mode
a) Ensure that electrical equipment is switched off before connecting to the generator.
b) Connect the plug of the electrical equipment into the appropriate socket.
c) The generator can supply 230 V AC.
12V DC mode
a) Set DC overload protector- Reset (12) to "ON"
b) Connect the DC cable to the DC output.
c) Clamp the red wire to the positive (+) terminal and the black wire to the negative (-) terminal
of the equipment you would like to use.
d) If the DC overload protector activates, wait for a few minutes and then press the DC breaker
shown on right.
USB application
The USB socket (16) should only be used for charging 5VDC Max. 2A mobile or digital equipment.
CAUTION!
• Be sure the total load is within generator rated output.
• Make sure that the appliance being connected is in good working order, if it begins to act
abnormally or stops suddenly, disconnect it from the generator.
• Any device with contains an inductive load e.g. devices that contain a motor may require more
current on startup.
3) Shutting Down the Generator
• Disconnect all appliances connected to the generator.
• Set the Engine ON/OFF Switch (11) to position "0".
EN